I need to remove the drive shaft (or stub axle) to replace the bolts for the CV joint on a Hewland LD 200 differential. Could someone explain the procedure? If I remove the side plate is it a simple matter of just removing circlip and sliding drive shaft out? I need to replace bolts on both sides (RT and Left)
I realize I could just cut off remain bolts an insert new bolts reversed, with nuts in between flange and case. This way does not seem correct because the threaded portion of the bolt does will not fit tightly in the drive shaft (stub axle) holes.
I am looking for the correct procedure for bolt replacement
I realize I could just cut off remain bolts an insert new bolts reversed, with nuts in between flange and case. This way does not seem correct because the threaded portion of the bolt does will not fit tightly in the drive shaft (stub axle) holes.
I am looking for the correct procedure for bolt replacement
Aucun commentaire:
Enregistrer un commentaire