I have a pair of large 1/2" thick high strength alloy 6061-T651 aluminum plates.
They are each 24" by 64", so these are not for big wide cars.
Length of car is not an issue since there are 2 separate plates.
However, they could be cut in half so they would work with any width.
They were necessary for me to do corner weighing and alignments in my old garage.
That garage had a steeper "fuel drainage" incline than most.
My current garage is dead flat and doesn't have any cracks- really unusual for San Jose.
Anyway, retiring to AZ later this year, so the plates are for sale.
$300 worth of aluminum was bought and cut to make them.
$50 for both. Includes jack-screws and lock nuts for leveling.
408-770-9901 Alum Rock area of San Jose
They are each 24" by 64", so these are not for big wide cars.
Length of car is not an issue since there are 2 separate plates.
However, they could be cut in half so they would work with any width.
They were necessary for me to do corner weighing and alignments in my old garage.
That garage had a steeper "fuel drainage" incline than most.
My current garage is dead flat and doesn't have any cracks- really unusual for San Jose.
Anyway, retiring to AZ later this year, so the plates are for sale.
$300 worth of aluminum was bought and cut to make them.
$50 for both. Includes jack-screws and lock nuts for leveling.
408-770-9901 Alum Rock area of San Jose
Alignment plates for AM, BM, FM narrow car
Aucun commentaire:
Enregistrer un commentaire